I would guess that the vast majority of lifters would have both safeties and J-hooks in the one inch section on all Titan racks these days, possibly even with a setup like Wilhelm's with the platform top higher than the rack feet.ĭid some video-sleuthing, and based on this post's video, a small female lifter (our very own would be just into the bottom of the one inch spacing with pin-pipe safties (might be different for a swing-in type, I think the bottom might have a pin (though possibly not needed) so you could only do a two inch increment for it to line up if it is out of the one inch section).
That's with a Rep Fitness AB-3100 bench, which is 17.5" high. My small chest and (I think) average to below-average arm length (or effective length when lying down, I had some trouble getting bar out of the top hooks on a Hammer Strength fixed bench without having to protract shoulders a bit - bad for tightness) has the safeties into the one inch section, and J-hooks just above the half-way point of the one inch section. when did you get the shorty one, you've had it for quite a while now right? I believe they fixed which end they were chopping for the shorty version (might have even seen a thread back in Egypt about them having fixed it, but not sure), based on what I have.
The hole spacing is the same on these which were ordered in August. Hold the phone!! I just checked my setup which is a full height rack, plus the shorty T-6 extension, so a pair of short uprights.
0 kommentar(er)
